UKT Support logo

Home
What's New
Contact Us


Search the Site
powered by FreeFind

Acer
Advent
Amstrad
Apple
Canon
Compaq
CTX
Epson
Hewlett Packard
Mitsubishi/Apricot
Packard Bell
Other Manufact.

File Extensions
Humour
Links
Microsoft
Reference
Scanner Support





 


Packard Bell Luna M/Board

Luna board diagram

Specification

  • Audio: VT1611A 18-audio - audio codec
  • Bios: AMI
  • Chipset : VIA Apollo Pro133A (VT82C694X system controller, VT82C686A PCI to ISA bridge)
  • CPU Support : Socket 370
    • Supports Intel PIII Coppermine FC-PGA (Flip-Chip Pin Grid Array) processor 600/100 - 850/100 Mhz.
    • Supports Intel PIII Coppermine FC-PGA (Flip-Chip Pin Grid Array) processor 600/133 - 1000/133 MHz
    • Note: above CPU's are only supported with the latest BIOS version.
    • 66/100/133 MHz Host bus speed processors are supported.
  • Expansion Slots : 2 PCI extension slots, 1 AGP connector, 1 Audio Modem Riser connector
  • Form Factor : ATX 24.4cm. x 20.0 cm Form Factor
  • RAM :
    • Supports 4 memory banks (2 slots) using three 168-pin unbuffered DIMM.
    • Supports single or double sided DIMMS with gold-plated contacts at a clock speed of 66, 100 or 133 MHz.

      CPU Bus FrequencyMemory Frequency Supported
      66 MHz66, 100 or 133 MHz
      100 MHz66, 100 or 133 MHz
      133 MHz100 or 133 MHz


    • Supports a maximum memory size of: 512 (128-bit technology) or 256 MB (64-bit technology) registered DIMMs or 1 GB unregistered DIMMS (256-bit technology)
    • Supports 3.3 V SDRAM DIMMs.
    • ECC memory checking is supported

Jumpers

JumperConfiguration
JBAT1 - Clear CMOS jumper1-2: Normal operation (default)
2-3: Clear current BIOS default settings
J5 - BIOS mode selection jumper1-2: CMOS and NVRAM are only cleared if they failed the checksum test
2-3: BIOS Setup is put in extended configuration mode (a maintenance menu is available, in which you can select the Clear Password option).
Open: BIOS recovery from the floppy
J12 - USB devices 1&2 power on function from S3 states jumperOpen: disable
Close: enable
J13 - USB devices 3&4 power on function from S3 states jumperOpen: Disable
Close: Enable