 Acer File Extensions |
Packard Bell Houston 4 M/Board
Specification
- Audio : SigmaTel STAC9700 Codec
- BIOS : Ami
- Chipset : Intel 810E chipset consisting of the Intel 82810E Graphic Memory Controller Hub (GMCH) and the 82801 I/O Controller Hub (ICH).
- CPU Support : Socket 370
- Supports Intel Celeron FC-PGA (Flip-Chip Pin Grid Array) processor 366/66 to 766/66 MHz.
- Supports Intel Celeron Coppermine FC-PGA processor 800/100 to 850/100 MHZ.
- Supports Intel PIII Coppermine FC-PGA processor 500/100 to 850/100 MHz.
- Supports Intel PIII Coppermine FC-PGA processor 533/133 to 1000/133 MHz.
- 66/100/133 MHz Host bus speed processors are supported.
- Note: above CPU's are only supported with the latest BIOS version.
- Form Factor : ATX 24.4×21.0 cm Form Factor
- RAM :
- Supports 2 memory banks using two 168-pin unbuffered DIMM.
- Supports single or double sided DIMMS with gold-plated contacts at a clock speed of 100 MHz.
- Supports a maximum memory size of 512 MB (128-bit technology) or 256 MB (64-bit technology) for SDRAM.
- Supports 3.3 V SDRAM DIMMs.
- ECC memory checking is not supported
- Video : Integrated on motherboard
Jumpers
| Jumper | Configuration |
|---|---|
| JP3 - Clear CMOS Settings | 1-2 : Normal operation (default) 2-3 : Clear current CMOS settings. |
| JP11 - Suspend to RAM | Open : Disable Suspend to RAM (default) Close : Enable Suspend to RAM |
| JP26 - Set Flash Memory | 1-2 : Normal (default) 2-3 : Restore Settings Open : Recovery |
| JP30 - USB Keyboard Wakeup | 1-2 : USB keyboard wakeup disabled (default) 2-3 : USB keyboard wakeup enabled |
| JP31 - Audio CODEC selection | 1-2: Primary 2-3: Disable CODEC Open: Secondary |
| JP34 - USB device wake up | 1-2: Wake up disabled 2-3: Wake up enabled (default) |
Note about the USB features: There is support for 4 USB ports on the motherboard, all of which are active at the same time (thus no need for a USB selection jumper). The jumper JP34 is used to activate Wake up from S3 state (one of the ACPI sleep modes).