UKT Support logo

Home
What's New
Contact Us


Search the Site
powered by FreeFind

Acer
Advent
Amstrad
Apple
Canon
Compaq
CTX
Epson
Hewlett Packard
Mitsubishi/Apricot
Packard Bell
Other Manufact.

File Extensions
Humour
Links
Microsoft
Reference
Scanner Support





 


Packard Bell Houston 3+r M/Board

Houston3+r board diagram

Specification

  • Audio : SigmaTel STAC970 Codec
  • BIOS : AMI
  • Chipset : Intel 810 chipset consisting of the Intel 82810 Graphic Memory Controller Hub (GMCH) and the 82801 I/O Controller Hub (ICH).
  • CPU Support : Socket 370
    • Supports Intel Celeron FC-PGA (Flip-Chip Pin Grid Array) processor 366/66 to 766/66 Mhz.
    • Supports Intel Celeron Coppermine FC-PGA processor 800/100 to 900/100 MHZ.
    • Supports Intel PIII Coppermine FC-PGA processor 600/100 to 1100/100 MHz.
    • 66/100 MHz Host bus speed processors are supported.
    • Note: above CPU's are only supported with the latest BIOS version.
  • Expansion Slots : 3 PCI slots.
  • Form Factor : ATX 24.4 x 21.0 cm Form Factor
  • RAM :
    • Supports 2 memory banks using two 168-pin unbuffered DIMM.
    • Supports single or double sided DIMMS with gold-plated contacts at a clock speed of 100MHz.
    • Supports a maximum memory size of 512 MB (128-bit technology) or 256 MB (64-bit technology) for SDRAM.
    • Supports 3.3 V SDRAM DIMMs.
    • ECC memory checking is not supported
  • Video : Integrated in chipset.

Jumpers

JumperConfiguration
JP3 - Clear CMOS Settings1-2 : Normal operation (default)
2-3 : Clear current CMOS settings.
JP11 - Suspend to RAMOpen : Disable Suspend to RAM (default)
Close : Enable Suspend to RAM
JP26 - Set Flash Memory1-2 : Normal (default)
2-3 : Restore Settings
Open : Recovery
JP30 - USB Keyboard Wakeup1-2 : USB keyboard wakeup disabled (default) 
2-3 : USB keyboard wakeup enabled
JP31 - Audio CODEC selection 1-2: Primary
2-3: Disable CODEC
Open: Secondary
P34 - USB device wake up1-2: Wake up disabled
2-3: Wake up enabled (default)

Note about the USB features: There is support for 4 USB ports on the motherboard, all of which are active at the same time (thus no need for a USB selection jumper). The jumper JP34 is used to activate Wake up from S3 state (one of the ACPI sleep modes.