Packard Bell Evergreen 2 M/Board
The differences between the Evergreen and the Evergreen 2 motherboard are:
- CPU: supports higher Pentium 4 frequencies ranging from 1.7 to 2 GHz
- Chipset: new revision of the i850, including the MCH rev A3 and the ICH rev B4
- Audio: new AD chipset (instead of Yamaha on Evergreen 1)
- BIOS: S3 mode support
- PC 2001 compliant
Specification
- Audio: AD1881A
- Bios: Phoenix
- Chipset: Intel 850 chipset consists of the 82850 Memory Controller Hub (MCH rev. A3) and the 82801BA I/O Controller Hub (ICH2 rev. B4).
- CPU Support :
- Socket PGA 423.
- Supports Intel P4 FC-PGA (Flip-Chip Pin Grid Array), 1.7 GHz and 2 GHz.
- 100 MHz (x 4 = 400 MHz) data bus support (quad-pumping technology).
- Form Factor : Full ATX (12 x 7.75 inch - 30.48 x 19.68 cm) Form Factor.
- I/O Controller : WINBOND W83627HF-AW
- RAM :
- Supports 4 memory slots (2x2 channels) using four 184-edge connector pads RIMMs with gold-plated contacts.
- Memory bus frequency: 400 MHz.
- Supports high speed 800 (PC800) MHz transfer rate.
- Serial Presence Detect (SPD) support.
- Operates from a 2.5 V supply (± 5%).
- Supports both ECC and non-ECC RIMMs.
- Low power and power-down self refresh modes.
- Supports a maximum memory size of 768 MB. Because memory modules have to be installed in pairs, this maximum can only be achieved using 2 x 256 MB + 2 x 128 MB memory modules.
Jumpers
Jumper | Configuration |
JBAT1 - Clear CMOS jumper | 1-2: Normal operation (default) 2-3: Clear current BIOS |
J16 - Speaker Out | 1-2: To speaker 2-3: To buzzer (default) |
JP1 - On-board audio | 1-2: Enable on-board audio codec (default) 2-3: Disable on-board audio codec |
J17 - BIOS write protect | Open: Normal (default) Closed: BIOS write protect |
J18 - Clear password | Open: Clear password Closed: Normal (default) |
|