UKT Support logo

Home
What's New
Contact Us


Search the Site
powered by FreeFind

Acer
Advent
Amstrad
Apple
Canon
Compaq
CTX
Epson
Hewlett Packard
Mitsubishi/Apricot
Packard Bell
Other Manufact.

File Extensions
Humour
Links
Microsoft
Reference
Scanner Support





 


Packard Bell Apollo M/Board

Apollo board diagram

Specification

  • BIOS : Ami BIOS.
  • Bus : 133 MHz front side bus is supported.
  • Cache : Integrated on the SEC cartridge.
  • Chipset : Intel 810E chipset (Intel 82810E Graphic Memory Controller Hub (GMCH) and the 82801 I/O Controller Hub (ICH))
  • CPU Support : The motherboard supports the following processors, either in a SEC (Single Edge Contact) or SEC2 cartridge, and placed in SLOT 1:
    • Pentium III: 450/100, 500/100, 550/100, and 600/100 including cache on CPU PCB.
    • Pentium III Coppermine: 533/133, 600/133 and above including cache on Die.
    • Pentium II: 233/66, 266/66, 300/66, 333/66, 350/100, 400/100 450/100 MHz including cache on CPU PCB.
  • Expansion Slots : Three 32-bit Master PCI Bus slots.
  • Form Factor : ATX
  • RAM :
    • Supports 2 memory banks using two 168-pin unbuffered DIMM.
    • Supports single or double sided DIMMS with gold-plated contacts at a clock speed of 100 MHz.
    • Supports a maximum memory size of 512 MB (128-bit technology) or 256 MB (64-bit technology) for SDRAM.
    • Supports 3.3 V SDRAM DIMMs.
    • ECC memory checking is not supported.
    • Suspend To RAM support.
  • Video : Integrated in chipset

Jumpers

JumperConfiguration
JP6 - Clear BIOS Settings1-2 : Normal operation (default)
2-3 : Clear current BIOS settings.
JP18 - Flash Memory1-2 : Normal operation (default)
2-3 : Restores safe values + automatically loads the BIOS setup on boot.
OPEN : Flash and recover a corrupted BIOS
JP11 - Suspend to RAMOPEN : Disable Suspend to RAM (default)
CLOSE : Enable Suspend to RAM
J21 - USB Keyboard Wake up 1-2 : USB keyboard wake up enabled
2-3 : USB keyboard wake up disabled
JP21 - Audio CODEC1-2 : Primary
2-3 : Disabled (default)
OPEN : Secondary
JP31 - USB1-3, 2-4 : Front USB enabled, top-rear USB disabled (default)
1-3, 2-4 : Front USB disabled, top-ear USB enabled

JP10 & JP17 - 2×3-pin jumpers to set bus speed

SettingJP10JP17
Auto1-21-2
66MHz2-32-3
100MHzOPEN2-3
133MHzOPENOPEN