|
|
Packard Bell 911 M/Board
Item | Description | Item | Description |
A | Wake-On-Ring Header | T | IrDA Connector |
B | Power-On Mode Jumper (JP1) | U | FDD Connector |
C | Creative Labs ES1373 Audio Chipset | V | Power On/Off Switch Header (JRMS) |
D | AUX Line In (J5),Modem In (J6) & CD In (J8) | W | Primary IDE Connector |
E | MIDI/Game Port, Line In, Line Out & Mic In Jacks | X | Secondary IDE Connector |
F | Front Side USB Header (J14) | Y | Core/Bus Ratio Jumper Block (SW1) |
G | Front Side USB Select Jumper Block (J15) | Z | AGP Port |
H | Parallel & Serial Ports | AA | Battery |
J | Stacked USB Ports | BB | Piezo Speaker |
K | PS/2 Keyboard & Mouse Ports | CC | Wake-On-LAN Header |
L | Primary Power Connector | DD | Front Panel Header (J13) |
M | SEC Processor Cartridge Interface (SLOT1) | EE | CMOS Clear Jumper (JGA1) |
N | Intel 82443ZXPCI AGP Controller (PAC) | FF | Power Management LED Header (JGL1) |
P | CPU Heatsink Support Bar | GG | Power Management Switch Header (JGS1) |
Q | CPU Heatsink Fan Power Header | HH | Intel 82371EB Chipset (PIIX4E) |
R | DIMM Slots | JJ | Password Clear Jumper (J16) |
S | Flash BIOS | KK | PCI Slots |
| | LL | ISA Slot |
Specification
- Audio : Creative Labs ES1373 Audio Chipset.
- Battery : CR2032 Lithium 3V Socketed.
- BIOS : Intel E28F002BXT80 2 MBit Flash EPROM.
- Bus : PCI/ISA based system bus. 100MHz maximum bus speed.
- Cache : 32K level 1 cache. 0, 128, 256 or 512KB level 2 cache in the Single Edge Contact cartridge.
- Chipset : Intel 82443ZX PCI AGP Controller (PAC). Intel 82371EB PCI chipset (PllX4E).
- CPU : Intel PentiumII, Celeron and Katmai processors from 333 to 500 MHz and faster.
- Interfaces :
- 2 DB-9 Serial ports
- 1 DB-25 Parallel port
- 1 PS/2 keyboard port
- 1 PS/2 mouse port
- 2 USB connector
- 1 DB-15 MIDI/Game port (Optional)
- 3 Stereo mini-jacks for Line In, Line Out & Mic (Optional)
- RAM : 2 168-pin DIMM sockets, upgradeable to 256MB total SDRAM.
- Video : No on-board video.
Jumpers
Jumper | Function | Configuration |
JGA1 | CMOS Clear | 1-2 - Normal Operation 2-3 - Clear CMOS Data |
J16 | Password Clear | Closed - Normal Operation Open - Clear Password |
JP1 | Power On Mode | Closed - Select Boot-up by switch (Default) Open - Select Immediate Boot-up/Last State |
Core/Bus Ratio Header (SW1)
Jumper 1 | Jumper 2 | Jumper 3 | Jumper 4 | Core/Bus Ratio |
On | Off | On | On | 2.5 |
On | On | Off | On | 3 |
On | Off | Off | On | 3.5 |
On | On | On | Off | 4 |
On | Off | On | Off | 4.5 |
On | On | Off | Off | 5 |
On | Off | Off | Off | 5.5 |
Off | On | On | On | 6 |
Off | Off | On | On | 6.5 |
Off | On | Off | On | 7 |
Off | Off | Off | On | 7.5 |
Off | On | On | Off | 8 |
Note - If the CPU is 400MHz then the Core/Bus Ratio is 4.
Upgrades
Cache Upgrade. The 911 motherboard comes with 0, 128K, 256K or 512K Level 2 cache, depending on the processor. The cache is not upgradeable.
- CPU Upgrade. This motherboard can accommodate the following CPUs:
- Pentium II 233, 266, 300, 333, 350, 400, 450 MHz with MMX technology.
- Pentium II/Celeron 266, 300, 333, 366 MHz with MMX technology (66MHz Host Bus frequency).
- Pentium II/Pentium III 400, 450, 500 MHz
- Single Edge Contact (SEC) cartridge. Uses the SLOT1 CPU socket. Not keyboard switchable. Disable cache to slow down the system.
RAM Upgrade. Maximum on Motherboard: 256MB. Uses 8/16/32/64/128 MB DIMMs, 60ns or faster SDRAM DIMMs Supports only non-parity DIMM modules. The 168-pin DIMM sockets will support PC66/PC100 unbuffered 3.3V 1MBx64 (8MB), 2MBx64 (16MB), 4MBx64 (32MB), and 8MBx64 (64MB) and 16MBx64 (128MB) SDRAM DIMMs. PC100-compliant (100MHz) DIMMS should be used with any processor operating at 350MHz or faster. Bank 1 will be populated as the default from the factory. No configuration jumpers: BIOS detects memory size, and memory type. This motherboard will not accept 36-bit DIMM modules (parity).
|
|